Parallel/USB settings
msh> authfree [parallel | usb] [on|off]
• To enable authfree, set to on. To disable authfree, set to off. Always specify the interface.
Authentication exclusion control initialization
msh> authfree flush
autonet
Use the “autonet” command to configure AutoNet parameters.
View settings
The following command displays the current AutoNet settings:
msh> autonet
Configuration
You can configure AutoNet settings.
msh> autonet {on|off}
• {on} means “active” and {off} means “inactive”.
Current interface priority configuration display
msh> autonet priority
Interface priority configuration
msh> autonet priority “interface_name”
• You can give interface's AutoNet parameter priority.
• Priority settings are available when multiple interfaces are installed.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
• If an interface is not selected, the current interface connection settings remain in effect.
• For details about AutoNet, refer to autonet parameters.
Remote Maintenance by telnet
167
To Next Page
Loading...
