5. Select [LDAP Auth.].
If you do not want to use user authentication management, select [Off].
6. Select the LDAP server to be used for LDAP authentication.
7. Select the "Printer Job Authentication" level.
You can specify the IPv4 address range to which this setting is applied, and whether or not to apply
the setting to the parallel and USB interfaces.
If you select [Entire] or [Simple (All)], proceed to "Selecting Entire or Simple (All)".
If you select [Simple (Limitation)], proceed to "Selecting Simple (Limitation)".
For a description of the printer job authentication levels, see "Printer Job Authentication".
LDAP Authentication
67
To Next Page
Loading...
