194
When "SET MASTER ROLL PROPERLY" is Displayed
Close the “master cover”.
Slide the “scanner unit” to return it to its original
position.
The master will be automatically pulled in.
Master cover
Pull out the “master”, insert it under the “bar”,
and align its leading edge with the “set line”.
●
Do not touch the heat generator of thermal
head. Doing so may cause damages, leading
to a malfunction of master making.
Thermal head heat generator
IMPORTANT
IMPORTANT
Roll Master
Set the roll master
so that its leading
edge can be seen
from the window.
● Be sure to pull out the master in the correct
direction.
● Pull out the master until it can be seen from
the window and set.
To Next Page
Loading...
