40
Adjusting Darkness
Adjusting Darkness
Scan Darkness
Touch “DARKNESS”.
Touch “DARK” if the color of the document is light.
Touch “LIGHT” if the color of the document is dark.
Touch “OK”.
Scan darkness adjusted in step 2 is set.
● To reset to standard:
* Touch “DARKNESS” again and adjust scan darkness
to “±0”, and then touch “OK”.
* Press the
RESET key. In this case, all settings
are reset to Standard Mode.
IMPORTANT
REFERENCE
How to Adjust Scan Darkness
Make sure that the main screen is displayed on the
touch panel LCD.
If the test print made after master making is too light, adjust the print darkness. If you cannot
adjust the print darkness suffi ciently to give a satisfactory print, adjust the master darkness.
● You can print immediately after adjusting the print darkness.
● If you adjust the master darkness, you must repeat the master making process before making prints.
● If you adjust the scan darkness, you must repeat the master making process before making prints.
IMPORTANT
Scan darkness can be adjusted in 5 steps.
If thin line is not printed, adjust the scan darkness.
When the color of the document is light, touch “DARK”.
When the color of the document is dark, touch “LIGHT”.
● Set scan darkness before starting master making.
● Thin line may not be printed even scan darkness is adjusted.
To Next Page
Loading...
