46
Adjusting Print Position
Print Position Adjustment
Press the PRINT POSITION keys to adjust.
The print position adjustment screen is displayed on
the touch panel LCD. Each press of “CURSOR” keys
changes the print position by 0.5mm.
● To reset to standard:
* Press the center key of the PRINT POSITION key.
* Press the
RESET key. In this case, all settings
are reset to Standard Mode.
Adjustment keys (cursors) are also displayed on the
touch panel LCD. Touching the CURSOR keys adjusts
print position as well as PRINT POSITION keys. If you
do not touch any PRINT POSITION key for about 5
seconds, the display returns to the main screen.
IMPORTANT
REFERENCE
Make sure that the main screen is displayed on the
touch panel LCD.
REFERENCE
● You can also display the print position adjustment
screen by touching “PRINT POSITION” on the touch
panel LCD.
After master making has fi nished, you can fi ne-tune the position of the printed image 15mm
in the vertical direction and
10mm in the horizontal direction.
Adjusts only vertical print position using PRINT POSITION keys.
(“Adjusting horizontal print position” → see p.47)
● You cannot adjust print position while printing.
Stop the operation with the
STOP key to adjust the position.
● You can adjust print position when “PRINT POSI ADJ (p)” (Print Position Adjustment While
Printing) is “ON”. In this case, adjustment range is
30 steps in vertical and 20 steps in
horizontal. (“Print Position Adjustment While Printing” → see p.153)
● When “ NARROW PAPER” is “ON”, print position should be “
0.0”.
(“Narrow Paper” → see p.112)
To Next Page
Loading...
