• If you want to change the registered contents of the specified destination or
register a new destination, press and then select [Add/Edit Address Book]
to change or newly register the destination on the address book screen.
page94”Registering/Changing/Deleting Fax Numbers in the Address Book”
When you select [Add/Edit Address Book], the settings you have made will be
reset. Close the address book screen, and then specify the destination again on
the fax screen.
6. On the [Settings] screen, specify [Sender] as necessary.
• You can select a sender from the users for which the [Use as Sender] check box
was selected when they were being registered to the address book.
See "Registering/Changing/Deleting E-mail Addresses in the Address Book",
User Guide (HTML).
• When a login user is operating the machine, the login user becomes the sender.
• To receive a transmission result by e-mail, select [Notification of Result].
• To print the sender's name on the page received at the destination, select
[Stamp Sender Name].
7. Press [Start].
After scanning the originals, you can check and operate the originals waiting to be
sent that are stored in the memory until the transmission is complete.
See "Confirming and Handling a Document in the Fax Queue", User Guide (HTML).
Press [Job Status/Stop] [Transmission Result] to confirm if the fax document
was sent correctly.
page147”Confirming the Transmission Result on the Fax Screen”
• If the telephone line you are connected to requires time to connect to the public line
after you dial the external number, enter a [Pause] after entering the number to
specify the time to wait before dialing the number. The machine pauses for about
two seconds for each single [Pause] entered.
To Next Page
Loading...
