You cannot access the
machine using Web
Image Monitor.
There is a problem with
the connection between
the machine and the
computer.
Check the cable connecting the
machine and the computer, and
disconnect and then connect the
cable again. Also, check the
connection to the hub or router,
and turn off and on the power of
the device if possible. Next, turn
off the power of the machine,
wait for 10 seconds or more after
confirming that the main power
indicator is turned off, and then
turn on the power.
page19”Turning On and Off the
Power”
A proxy server is
specified.
In the proxy setting of the Web
browser, specify the IP address
of the machine as an exception.
You can check the IP address in
[Check Status] "Network".
"There is a problem with
this website's security
certificate." is displayed
and you cannot connect
to the machine when
accessing the machine
using Web Image
Monitor.
[Permit SSL/TLS
Communication] is set
to [Ciphertext Only].
Click [Continue to this website
(not recommended).].
To specify not to display the
message, log in to the machine in
the administrator mode, and
specify [Ciphertext/Cleartext] in
[SSL/TLS] "Permit SSL/TLS
Communication" under [Device
Management] [Configuration]
"Security".
"https" is entered at the
beginning of the URL.
Do not enter "s" after "http".
To Next Page
Loading...
