• When using paper that has a horizontal width of 457.2–900 mm (18.00–
35.5 inches), set the paper so that its leading edge protrudes from the
banner paper guide tray.
• When using paper that has a horizontal width of 148–457.2 mm (5.83–
18.00 inches), set the paper as loading paper into the bypass tray.
• If you cannot load a certain type of paper as shown in the illustrations above, refer
to the loading method for a different length of paper to load that paper. If you still
cannot load the paper, support the paper to keep it straight so it does not the fold.
• You can load up to 10 sheets of recommended paper (297‐1200 mm (11.7‐47.3
inches)) into the banner paper guide tray. When loading multiple sheets of paper
into the banner paper guide tray, be sure to separate them one by one before
loading them.
• When [Notification Sound] is set to [No Sound], it does not sound if you load paper
into the banner paper guide tray.
• Remove the sheets of printed banner paper one by one after every printing.
• When you output banner paper, support the printed paper gently so it does not fall
from the output tray.
To Next Page
Loading...
