1 March, 2000 SERVICE PROGRAM MODE
4-61
Service
Tables
8: 6-90 to 99 (Paper feed and separation pressures for different paper types)
These SP modes determine the paper feed and separation pressures that are
automatically applied during paper feed. The user adjusts these pressures by
selecting a paper type (normal, thick, special, user 1, user 2), and then by selecting
how often non-feeds and double feeds are occurring.
The user customizes the user 1 and user 2 types by selecting from 5 choices.
These choices can be seen in the description for SP 2-400 and 2-401. Each of
these 5 choices has a set of feed and separation pressures (refer to Detailed
Section Descriptions – Paper Feed).
6-090: Special paper, feed pressure
6-091: Normal paper, feed pressure
6-092: Thick paper, feed pressure
6-093: User 1 paper, feed pressure
6-094: User 2 paper, feed pressure
6-095: Special paper, separation pressure
6-096: Normal paper, separation pressure
6-097: Thick paper, separation pressure
6-098: User 1 paper, separation pressure
6-099: User 2 paper, separation pressure
The settings for user 1 and user 2 depends on the type of paper that the user has
set these up for (see SP 2-400 and 2-401).
9: 6-100 (Paper delivery table wing angle)
The machine lifts or lowers the wings depending on the paper type selected by the
user (standard, special, thick, user 1, user 2).
The settings for user 1 and user 2 depends on the type of paper that the user has
set these up for (see SP 2-400 and 2-401).
10: 6-101 (Paper clamping)
Whether the machine clamps the paper or not depends on the paper type selected
by the user (standard, special, thick, user 1, user 2).
The settings for user 1 and user 2 depends on the type of paper that the user has
set these up for (see SP 2-400 and 2-401).
11: 6-130 (Drum master clamper registration)
This determines how far after the leading edge the master is clamped.
A larger value clamps the master further away from the leading edge, and moves
the image closer to the leading edge of the paper.
Do not use this SP to adjust leading edge registration. Use SP6-2 for that.
To Next Page
Loading...
