1 March, 2000 INSTALLATION REQUIREMENTS
3-1
Installation
3. INSTALLATION
3.1 INSTALLATION REQUIREMENTS
The installation location should be carefully chosen, because the environmental
conditions could greatly affect the performance of the machine.
3.1.1 REQUIRED ENVIRONMENTAL CONDITIONS
1. Temperature –10 to 30
°
C (50 to 86
°
F)
2. Humidity –20 to 90 % RH
3. Place the machine on a strong and level base. The machine must be leveled
within 5 mm both front to rear and left to right.
3.1.2 ENVIRONMENTS TO AVOID
1. Locations exposed to direct sunlight or strong light (more than 1,500 lux).
2. Areas with corrosive gases.
3. Dusty areas.
4. Locations directly exposed to cool air from air conditioners or reflected heat
from space heaters. (Sudden temperature changes from low to high or vice
versa may cause condensation within the machine.)
3.1.3 POWER CONNECTION
1. Securely connect the power cord to a power source.
2. Make sure that the wall outlet is near the machine and easily accessible.
3. Make sure the plug is firmly inserted in the outlet.
4. Avoid multi-wiring.
5. Voltage must not fluctuate more than 10%.
6. Do not press anything on the power cord.
7. Always plug the power cord into a properly grounded outlet.
8. Power Source: 220-240V, 50/60Hz, 1.6A or more. Please be sure to connect
the power cord to a power source of this type.
To Next Page
Loading...
