MACHINE INTERIOR 1 March, 2000
1-8
1. Main Switch
Use to turn the power on or off.
2. Paper Alignment Wing
Knobs
Use to lift or lower the paper alignment wings.
3. Paper Alignment Wings
Lift or lower the wings depending on the type of
paper being used.
4. Paper Delivery End Plate
This plate aligns the leading edge of prints.
5. Paper Delivery Tray
Completed prints are delivered here.
6. Paper Delivery Side Plates
These plates align the prints on the paper
delivery tray.
7. Handle E1
Use to pull out the master eject unit.
8. Guide Plate Lever
Turn to remove misfed paper.
9. Ink Holder
Set the ink cartridge in this holder.
10. Drum Unit Lock Lever B1
Lower to unlock and pull out the drum unit.
11. Drum Unit
The master is wrapped around this unit.
12. Exposure Glass (also
called the Contact Glass)
Position originals here face down for printing.
13. Platen Cover or Document
Feeder (Option)
Lower this cover over an original on the
exposure glass.
14. Trailing Edge Guides
Swing out these guides when you use A4, 8
1/2
"
x 11"
ä
, or B5
ä
paper.
To Next Page
Loading...
