PAPER FEED SECTION (MAIN BODY) 1 March, 2000
6-22
For the Paper Bank Unit - Tray 2
To ensure that the paper reaches the registration roller (main body) properly.
Changing the paper feed motor stop timing with SP6-143-1 changes the paper
feed length for the paper feed roller.
1. Turn on the main switch, then access the SP mode.
2. Enter SP6-143-1.
3. Increase or decrease the value on the display.
NOTE:
1) Before changing the value, check the current setting, in case you
need to recover the previous setting. (Default for SP6-143-1: “14”)
2) Changing the value by +1 increases the paper feed motor’s on-time
and feeds the paper an extra 0.3mm.
4. Leave the SP mode, then check the paper feed performance. If the problem still
occurs, repeat the above steps.
To Next Page
Loading...
