Copying
112
2
A Set the tray for the slip sheet.
You can select the tray for slip sheets using Tray Paper Settings in System Settings.
The paper for slip sheets should be of the same size and orientation as the
copy paper.
B Press [Cover / Slip Sheet].
C Press [Slip Sheet].
D Select [Copy] or [Blank], and then press [OK].
E Select the paper tray that contains the sheet paper to copy the originals.
When using OHP transparencies, open the bypass tray or set Paper Tray 2.
F Place the originals, and then press the {Start} key.
Note
❒ When loading OHP transparencies, press the {q} key and then select
[OHP Sheet] in the special paper settings.
Reference
p.37 “When Copying onto Special Paper”
“Tray Paper Settings”, General Settings Guide
To Next Page
Loading...
