Ricoh MP 2510 - When Copying Onto Custom Size Paper

Copying
36
2
When Copying onto Custom Size Paper
Makes copies onto custom size paper from the bypass tray.
A Open the bypass tray, and then push up the paper guide release lever.
B Insert the paper face-down, adjust the paper guide, and then push down
the paper guide release lever.
C Press the {q} key.
D Press [Custom Size].
E Enter the vertical size of the paper using the number keys, and then press
[q].
F Enter the horizontal size of the paper using the number keys, and then
press [q].
If [Horiz.] is not highlighted, press [Horiz.].
G Press [OK].
H Place originals, and then press the {Start} key.
I When the copy job is finished, press the {Clear Modes} key to clear the settings.
Note
❒ If you make a mistake in step
E
or
F
, press [Clear] or the {Clear/Stop} key,
and then enter the value again.
❒ To register the custom size entered in
F
, press [Program] and then press [Exit]
in the confirmation screen.