Copying from the Bypass Tray
33
2
Copying from the Bypass Tray
The bypass tray allows you to copy non-standard paper.
Important
❒ When copying from the bypass tray, select [1 Sided] for copying in [Dup./Com-
bine/Series] (for example [1 Sided] → [1 Sided] or [2 Sided] → [1 Sided]).
❒ Paper has a vertical length of 90-297 mm (3.55-11.69 inch) and a horizontal
length of 148-600 mm (5.83-23.6 inch) can be copied from the bypass tray.
❒ The machine can automatically detect the following sizes as standard size
copy paper:
•Metric version: A3L, A4K, A4L, A5L, 8" × 13"L, B4 JISL, B5 JISK,
B5 JISL, B6 JISL
• Inch version: 11" × 17"L, 8
1
/
2
" × 14"L, 8
1
/
2
" × 11"L, 5
1
/
2
" × 8
1
/
2
"L,
10" × 14"L
❒ If you want to use the size of paper other than the above, be sure to specify
the size.
❒ Select the paper size when making horizontal copies.
❒ When copying on OHP transparencies or paper heavier than 128 g/m
2
(about
34 lb.), you need to specify the type and size of paper in “Special Paper”.
❒ The maximum number of sheets you can load into the bypass tray depends
on paper type. The number should not exceed the upper limit.
❒ Some kinds of envelope might cause misfeed and wrinkle. If this happens,
push down the fusing unit's green lever. See “Envelopes”. Also, be sure to
place the front face of the envelope downward.
❒ Paper of 433 mm (17.0") in length, or larger, is likely to jam, crease, or not feed
in properly.
❒ When copying onto envelopes, see “Envelopes”.
To Next Page
Loading...
