Ricoh MP 2510 - Changing the Stamp Position; Specifying the First Printing Page and Start Number (P1,P2

Copying
98
2
Changing the stamp position
Changes the stamp position.
A Press [Change] under Stamp Position.
B Select the desired position, and then press [OK].
Specifying the first printing page and start number (“P1,P2...”, “-1-,-2-...”, “P.1,P.2...”,
“1,2...”)
Below explains the example when “P1, P2 …” is selected. The steps are the same
for other cases.
A Press [Change] on the right side.
B Press [First Printing Page], enter the original page number from which to start
printing with the number keys, and then press the {q} key.
C Press [Numbering from / to], enter the number of page from which to start
numbering with the number keys, and then press the {q} key.
The example below shows when the first printing page is “2”and the start
number is “3”.
GCANPE2J