Basic Procedure
25
2
Left Original Beeper
The beeper sounds and an error message is displayed when you leave your orig-
inals on the exposure glass after copying.
Note
❒ For details, see “General Features”, General Settings Guide.
Reference
“General Features”, General Settings Guide
Job Preset
You can make settings for the next copy job while copying is in progress.
When the current copy job is finished, the next copy job will start automatically.
A Press [NextJob] when “Copying...” appears.
B Make settings for the next copy job.
C Place the originals in the ADF, and then press the {Start} key.
All originals are scanned.
D Press [To "Printing"].
The initial copy display appears.
Following the current copy job, the next job starts automatically.
Note
❒ You can switch the display to the current copy job by pressing [To "Printing"].
You can switch the display to the preset job by pressing [To "Reserving"].
To Next Page
Loading...
