Placing Originals
22
1
Placing Custom Size Originals
When placing custom size originals in the ADF, specify the size of the originals.
Important
❒ Paper that has a horizontal length of 128–1,260 mm (5.1"-49.6") and a vertical
length of 105–297 mm (4.2"-11.6") can be specified.
A Press [Special Original].
B Press [Custm Size Origi.].
C Enter the horizontal size of the original with the number keys, and then
press [q].
D Enter the vertical size of the original with the number keys, and then press
[q].
E Press [OK].
F Place the originals, and then press the {Start} key.
Note
❒ If you make a mistake in step
C
or
D
, press [Clear] or the {Clear/Stop} key in
step
C
, and then enter the value again.
To Next Page
Loading...
