3. Special Operations under Windows
Printing Files Directly from Windows
You can print files directly using Windows commands. For example, you can print PostScript files for
PostScript 3.
Windows 95/98/Me
You can print files directly using ftp or sftp command.
Windows 2000/XP/Vista, Windows Server 2003, Windows NT 4.0
You can print files directly using lpr, rcp ftp or sftp command.
Setup
Follow the procedure below to make network environment settings.
1. Enable TCP/IP with the control panel, and then set up the printer's network environment
about TCP/IP including IP addresses.
TCP/IP of the printer is set as default.
2. Install a TCP/IP in Windows to set up the network environment.
Consult the network administrator for the local setting information.
3. To print under Windows 2000/XP/Vista, Windows Server 2003, install “Printing service
for UNIX” as the network application. To print under Windows NT 4.0, install “Microsoft
TCP/IP printing” as the network application.
• p.144 "Using DHCP"
Using a Host Name Instead of an IPv4 Address
When a host name is defined, you can specify a printer by host name instead of IP address. The host names
vary depending on the network environment.
When using DNS
Use the host name set to the data file on the DNS server.
131
To Next Page
Loading...
Need help?
General