• add: To add new records and store the old records.
• When CNAME overlaps, it is always changed, irrespective of settings.
CNAME registration
msh> dns cname {on|off}
• You can specify whether to register CNAME.
• {on} means “active” and {off} means “inactive”.
• The CNAME registered is the default name beginning with rnp. CNAME cannot be changed.
A records registration
msh> dns arecord {dhcp|own}
• dhcp: You can specify the method of registering an A record when the dynamic DNS function
is enabled and DHCP is used.
• own: To register an A record using the printer as the DNS client.
The DNS server address and the domain name already designated are used for the registration.
Record updating interval settings
msh> dns interval [1-255]
• You can specify the interval after which records are updated when using the dynamic DNS
function.
• The updating interval is specified hourly. It can be entered between 1 and 255 hours.
• The default is 24 hours.
resolv.conf display
msh> dns resolv
Specifying the protocol when asking names during dual stacking
msh> dns resolv protocol {ipv4|ipv6}
• Appears during dual stacking only.
domainname
Use the “domainname” command to display or configure the domain name settings.
You can configure the Ethernet interface,or IEEE 802.11 interface.
View settings
The following command displays the current domain name:
msh> domainname
Interface domain configuration
msh> domainname “interface_name”
Remote Maintenance by telnet
71
To Next Page
Loading...
Need help?
General