smb
Use the “smb” command to configure or delete the computer or workgroup name for SMB.
Computer name settings
msh> smb comp “computer name”
• Set computer name using up to 15 characters.
• Names beginning with “RNP” or “rnp” cannot be entered.
Working group name settings
msh> smb group “work group name”
• Set workgroup name using up to 15 characters.
Comment settings
msh> smb comment “comment”
• Set comment using up to 31 characters.
Notify print job completion
msh> smb notif {on|off}
• To notify print job completion, specify “on”. Otherwise, specify “off”.
Deleting computer name
msh> smb clear comp
Deleting group name
msh> smb clear group
Deleting comment
msh> smb clear comment
View protocol
msh> smb protocol
snmp
Use the “snmp” command to display and edit SNMP configuration settings such as the community name.
View settings
msh> snmp
• Default access settings 1 is as follows:
Community name:public
IPv4 address:0.0.0.0
IPv6 address:::
2. Monitoring and Configuring the Printer
84
To Next Page
Loading...
Need help?
General