IPX address:00000000:000000000000
Access type:read-only
Effective Protocol:IPv4/IPv6/IPX
• Default access settings 2 is as follows:
Community name:admin
IPv4 address:0.0.0.0
IPv6 address:::
IPX address:00000000:000000000000
Access type:read-write
Effective Protocol:IPv4/IPv6/IPX
• If “-p” is added, you can view settings one by one.
• To display the current community, specify its registration number.
Display
msh> snmp ?
Community name configuration
msh> snmp “number” name “community_name”
• You can configure ten SNMP access settings numbered 1-10.
• The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for
Client if “public” is not registered in numbers 1-10. When changing the community name, use
SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings.
• The community name can be entered using up to 15 characters.
Deleting community name
msh> snmp “number” clear name
Access type configuration
msh> snmp “number” type “access_type”
Access type Type of access permission
no not accessible
read read only
write read and write
trap user is notified of trapmessages
Remote Maintenance by telnet
85
To Next Page
Loading...
