Mode settings
You can set the Bluetooth operation mode to {private} or {public}.
msh> btconfig {private|public}
• The default is {public}.
devicename
Use the “devicename” command to display and change the printer name.
View settings
msh> devicename
Printer name configuration
msh> devicename name “string”
• Enter a printer name using up to 31 alphanumeric characters.
• Set single names for each printer.
Printer name initialization
msh> devicename clear name
• Reset the printer name to its default.
dhcp
Use the “dhcp” command to configure DHCP settings.
View settings
The following command displays the current DHCP settings.
msh> dhcp
Configuration
You can configure DHCP.
msh> dhcp “interface_name” {on|off}
• Click {on} to enable dhcp. Click {off} to disable DHCP.
• If the DNS server address and domain name are obtained from DHCP, be sure to click {on}.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Remote Maintenance by telnet
67
To Next Page
Loading...
