Ricoh MPC6000 - Show; Slp

msh> set ipp {up|down}
msh> set ipp6 {up|down}
msh> set http {up|down}
msh> set http6 {up|down}
msh> set bonjour {up|down}
msh> set bonjour6 {up|down}
msh> set ssh {up|down}
msh> set ssdp {up|down}
msh> set nbt {up|down}
msh> set sftp {up|down}
msh> set sftp6 {up|down}
msh> set wsdev {up|down}
msh> set wsdev6 {up|down}
• If “wsdev” and “wsdev6” are enabled simultaneously, both appear as “up” on the protocol
information display, but both use IPv4 for WS-Device and WS-Printer.
msh> set wsprn {up|down}
msh> set rhpp {up|down}
msh> set rhpp6 {up|down}
show
Use the “show” command to display network interface board configuration settings.
View settings
msh> show
• If “-p” is added, you can view settings one by one.
slp
Use “slp” command to view and configure SLP settings.
msh> slp ttl “ttl_val[1-255]”
• You can search the NetWare server using SLP in the PureIP environment of NetWare 5/5.1. Using
the “slp” command, you can configure the value of TTL which can be used by SLP multicast packet.
• The default value of TTL is 1. A search is executed only within a local segment. If the router does not
support multicast, the settings are not available even if the TTL value is increased.
• The acceptable TTL value is between 1 and 255.
Remote Maintenance by telnet
83
2