Ricoh MPC6000 - Help; Hostname

Setting the Domain Name
msh> domainname “interface_name” name “domain name”
• A domain name can be entered using up to 63 alphanumeric characters.
• The Ethernet interface and IEEE 802.11 interface will have the same domain name.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface Interface set
ether Ethernet interface
wlan IEEE 802.11 interface
Deleting the Domain Name
msh> domainname “interface_name” clear name
help
Use the “help” command to display the available command list and the procedures for using those
commands.
Command list display
msh> help
Display of procedure for using commands
msh> help “command_name”
hostname
Use the “hostname” command to change the printer name.
View settings
msh> hostname
IPv4 Configuration
msh> hostname “interface_name” “printer_name”
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning “RNP” (in either upper or lower case).
• The Ethernet interface and IEEE 802.11 interface will have the same printer name.
• wlan can be specified only when the IEEE 802.11 interface is installed.
• If you do not specify an interface, the Ethernet interface is selected automatically.
2. Monitoring and Configuring the Printer
72
2