IP TTL setting
msh> bonjour ip ttl [1-255]
You can specify the IP TTL (the number of routers a packet can pass through).
• The default is 255.
Resetting the computer name and location information
You can reset the computer name and location information.
msh> bonjour clear {cname|location}
• cname: Reset the computer name. The default computer name will be displayed when the
computer is restarted.
• location: Reset the location information. The previous location information will be deleted.
Interface configuration
msh> bonjour linklocal “interface_name”
• If you do not specify an interface, the Ethernet interface is selected automatically.
• If many types of interface are installed, configure the interface that communicates with linklocal
address.
• If you do not specify an interface, the Ethernet interface is automatically selected.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Setting IPP-SSL printing
msh> bonjour ippport {ipp|ssl}
• If IPP-SSL Printing is set to ssl, the IPP port number will appear as 443, and IPP-SSL printing can
be performed with higher security.
• If IPP-SSL Printing is set to ipp, the IPP port number will appear as 631. Port 631 is the port for
normal IPP printing.
btconfig
Use the “btconfig” command to make Bluetooth settings.
View settings
Bluetooth settings are displayed.
msh> btconfig
2. Monitoring and Configuring the Printer
66
To Next Page
Loading...
Need help?
General