Broadcast address configuration
msh> ifconfig “interface_name” broadcast “address”
Changing the interface
msh> ifconfig “interface” up
• When using the optional IEEE 802.11 interface unit, you can specify either Ethernet or IEEE
802.11 interface.
• To get the above addresses, contact your network administrator.
• Use the default configuration if you cannot obtain setting addresses.
• The IP address, subnet mask and broadcast address are the same as that for the ethernet interface
and IEEE 802.11 interface.
• TCP/IP configuration is the same for both Ethernet and IEEE 802.11 interface. If interfaces are
changed, the new interface inherits the configuration.
• Use “0x” as the initial two letters of a hexadecimal address.
info
Use the “info” command to display printer information such as paper tray, output tray, and printer language.
Printer information display
msh> info
• p.112 "Understanding the Displayed Information"
ipp
Use the “ipp” command to view and configure IPP settings.
Viewing settings
The following command displays the current IPP settings:
msh> ipp
IPP timeout configuration
Specify how many seconds the computer waits before canceling an interrupted print job. The time
can be entered between 30 to 65535 seconds.
msh> ipp timeout [30-65535]
2. Monitoring and Configuring the Printer
74
To Next Page
Loading...
Need help?
General