Ricoh MPC6000 - Configuring the Energy Saver Mode

3. On the [Edit] menu, click [Add New User].
4. Enter the user code and user name.
5. Select the check box of the functions applicable to the new user.
If the check boxes are unavailable, there is no restriction to use that function.
6. Click [OK].
The user is added, and [New] is displayed for [Status].
7. On the [Edit] menu, click [Apply Settings].
The settings are applied.
8. Click [Exit] on the [Files] menu to quit User Management Tool.
• For details about setting restrictions, see SmartDeviceMonitor for Admin Help.
Configuring the Energy Saver Mode
Follow the procedure below to configure Energy Saver mode.
1. Start SmartDeviceMonitor for Admin.
2. On the [Group] menu, point to [Search Device], and then click [IPv4], [IPX/SPX] or [IPv4
SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using IPv4 SNMPv3, enter the user authentication.
Using SmartDeviceMonitor for Admin
45
2