Ricoh PE-P4

Registration
Horiz. Tray1
Adjusts the horizontal registration for tray 1. If the
machine settings are reset to the factory defaults, this
value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Vert.Tray1
Adjusts the vertical registration for tray 1. If the machine
settings are reset to the factory defaults, this value does
not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Horiz.Tray2
Adjusts the horizontal registration for tray 2. If the
machine settings are reset to the factory defaults, this
value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Vert.Tray2
Adjusts the vertical registration for tray 2. If the machine
settings are reset to the factory defaults, this value does
not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Horiz Bypass Tray
Adjusts the horizontal registration for the bypass tray. If
the machine settings are reset to the factory defaults, this
value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Vert Bypass Tray
Adjusts the vertical registration for the bypass tray. If the
machine settings are reset to the factory defaults, this
value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Horiz.Dup Back
Adjusts the horizontal registration for the back side in
duplex mode. If the machine settings are reset to the
factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Vert.Dup Back
Adjusts the vertical registration for the back side in duplex
mode. If the machine settings are reset to the factory
defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Service Menu
133