Setting Items Values
[Ppr Trns Contact Mode] [High Speed]
[Low Pressure]
[Middle]
[Low]
[Low Speed For All Paper Type]
[Off]
*1
The jitter occurs when the leading or trailing edge of paper that passes through the paper transfer unit is
transmitted to the drum unit via the immediate transfer belt, causing banding.
046: [Ppr Trns Gap: On Timing]
Adjust the timing for the intermediate transfer belt and the paper transfer unit to come into contact during
paper contact/ separation.
Use this to reduce the jitter
*1
produced during paper separation. Also, use this to reduce the image
quality degradation during the separation.
To adjust the contact timing, press [−] to make the paper contact before its leading edge enters the
paper transfer roller, and press [+] to make it contact after its leading edge enters the paper transfer
roller.
This adjustment is available when 045: [Ppr Trns Contact Mode] is set to [High Speed], [Middle], [Low],
or [Low Speed For All Paper Type].
Setting Items Max. Value Min. Value Step Unit
[Ppr Trns Gap: On Timing] 50 -50 1 mm
*1
The jitter occurs when the leading or trailing edge of paper that passes through the paper transfer unit is
transmitted to the drum unit via the immediate transfer belt, causing banding.
047: [Ppr Trns Gap: Off Timing]
Adjust the timing for the intermediate transfer belt and the paper transfer unit to separate during paper
contact/separation.
Use this to reduce the jitter
*1
produced during paper separation. Also, use this to reduce the image
quality degradation during the separation.
To adjust the separation timing, press [−] to make the paper separate before its trailing edge exits from
paper transfer roller, and press [+] to make it separate after its trailing edge exits from the paper transfer
roller.
4. Details of Menu Items in Advanced Settings
138
To Next Page
Loading...
