[Machine: Paper Feed/ Output]
0103: [Registration Gate: Paper Buckle Amount]
Adjust the allowable amount of paper buckle when the edge of the paper is pressed against the
registration unit.
If the paper arching is too small or too large, the image may be misaligned or the paper may become
skewed.
This setting is only effective for paper of Paper Weight 1 to 4.
When paper of Paper Weight 5 to 9 is used, the value specified in [Registration Gate: Paper Buckle
Amount: Thick Paper] will be added.
Press [+] or [−] to adjust the degree of paper arching.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
[Tray 1] 0 5 -5 0.1 mm
[Tray 2]
[Tray 3]
[Bypass Tray]
[2 Sided]
[LCT]
0104: [Registration Gate: Paper Buckle Amount: Thick Paper]
Adjust the allowable amount of paper buckle for paper of Paper Weight 5 to 9 when the edge of the
paper is pressed against the registration unit.
By adjusting the degree of paper arching for relatively stiff thick paper, you can prevent image
misalignment and paper skew.
For paper of Paper Weight 1 to 4, specify [Registration Gate: Paper Buckle Amount].
Press [+] or [−] to adjust the degree of paper arching.
Setting Values
39
To Next Page
Loading...
