If [On] is selected, skew is corrected by bringing the sheets flush against a guide.
If [On (Reverse)] is selected, skew is corrected by bringing the sheets flush against a guide while the
registration roller rotates in reverse to prevent the Z-folded sheets from passing through the registration
roller.
Setting Items Values Default Value
[Z-fold Skew Correction] [On]
[On (Reverse)]
[Off]
[On (Reverse)]
0824: [Correct Z-fold Skew]
Adjust the length of sheets moved for Z-fold skew correction.
Use this if the Z-fold skew correction causes problems.
With the factory default setting of "0", the length of the sheets moved is set to 9 mm. Press [−] to reduce
the length. With "9", the length of sheets moved for Z-fold skew correction is reduced to "0".
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
[Correct Z-fold Skew] 0.0 0.0 -9.0 0.5 time(s)
0825: [Correct Z-fold Skew: Reverse]
Adjust how much the registration roller rotates in reverse for Z-fold skew correction.
Use this if the Z-fold skew correction causes problems.
With the initial factory setting of "0", the reverse rotation is set to 3 mm. By pressing [−], you can reduce
the reverse rotation down to "0".
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
[Correct Z-fold Skew: Reverse] 0.0 0.0 -3.0 0.5 time(s)
0826: [Maximum No. Stacked Sheets in Output Tray]
Specify the amount of paper stacked in Finisher SR5070 or Booklet Finisher SR5080.
Specify the amount of paper that can be stacked in the shift tray to avoid jamming (depends on the
paper size).
2. Details of Menu Items in Adjustment Settings for Skilled Operators
80
To Next Page
Loading...
