Using the [System] Menu
You can set basic functions required to use the machine. The machine can be used on factory default,
but the configuration can be changed depending on the condition of the user. The changed condition
holds even if the machine is turned off.
Energy Saver
Use Energy Saver mode to reduce the machine's power consumption.
You can specify how long the machine remains idle before it switches to Energy Saver mode.
When the machine is in Energy Saver mode, it requires time to start up when it receives a print job.
You can specify between 5 and 60 minutes as the idle time before switching to the Energy Saver
mode.
• 5 minutes
• 15 minutes
• 30 minutes
• 45 minutes
• 60 minutes
Default: [5 minutes]
Notify by Email
You can specify whether or not to send notification that a printer error has occurred to a particular
e-mail address.
Use the Web browser to specify e-mail address to send notification. See page 159 "Notifying the
Machine Status by E-mail".
• On
• Off
Default: [Off]
Unit of Measure
You can switch the measurement between "mm" and "inch".
• mm
• inch
(mainly Europe, Asia, and China)
Default: [mm]
(mainly North America)
Default: [inch]
Uni-direct.Prt.
You can configure the machine to eject ink only when the head is moving in a particular direction.
Using the [System] Menu
141
To Next Page
Loading...
