Ricoh Ri 100 - 2 Preparing for Printing; Setup Procedure

2. Preparing for Printing
This chapter describes installation and setup procedures.
Setup Procedure
This section explains the tasks necessary for printing.
Install and set up the machine by following the steps in the order shown.
Step Task Reference for Full Details
1 Check the installation environment. page 28 "Checking the Computer and
Installation Area"
2 Check the supplied items. page 32 "Checking the Supplied Items
and Unpacking the Machine"
3 Install the ink cartridges. page 35 "Installing the Ink Cartridges"
4 Plug in the power cord and turn on the
power, and then supply ink to the
machine.
page 38 "Plugging in the Power Cord
and Turning the Power On"
5 Load a fabric. page 72 "Loading Fabrics"
6 Perform a test print. page 117 "Printing a Configuration Page"
7 Connect the machine and computer and
install the software using "Quick Install".
page 43 "Connecting the Computer and
Installing the Software (USB Connection)"
page 50 "Connecting the Computer and
Installing the Software (Network
Connection)"
If you are using a Macintosh, see
page 169 "Using the Machine with a
Macintosh".
27