Printing
Using the Design Software, perform printing.
• Do not touch the cassette or put your hand in the machine while printing is performed.
• Do not open the top cover while printing is performed. Printing is forcibly interrupted and cannot be
resumed.
• When a garment misfeed error is indicated, see page 210 "Adjusting the Height of the Cassette".
• Do not print if no fabric is loaded on the cassette. It may cause the ink to stick to the cassette. After
printing without loading a fabric in the cassette, do the following:
Solutions if Printing Was Performed Without a Fabric Loaded in the Cassette
A4 standard tray or A5 tray:
1. Wipe the cassette with a dry cloth.
Do not use tissue paper because it makes the cassette dirty.
Use polythene gloves to avoid touching the ink directly.
Do not use chemicals such as thinner or ethanol.
2. Dry the remaining ink using the optional finisher or an iron.
Stains might remain on the cassette, which can still be used however.
When using the optional finisher, use it in dry mode.
When ironing, lay down a sheet of paper on the surface of the cassette, and apply the iron to
the paper.
After drying the ink, rub the surface of the cassette with a cloth to check whether or not the ink
is dry. If ink does not stick to the cloth, the ink has dried completely.
Multi tray:
1. Wipe the cassette with a damp and firmly wrung cloth or use a mild detergent.
Use polythene gloves to avoid touching the ink directly.
Use only a mild detergent and do not use chemicals such as thinner or ethanol.
1. Load the cassette in the cassette stand.
Place the rear side of the cassette in the cassette stand, and then push it in slowly all the way until
you hear it click.
You can check if the cassette is correctly positioned using the line on the left side of the cassette.
3. Printing on T-shirts
92
To Next Page
Loading...
