Connecting the Computer and Installing the
Software (Network Connection)
Connect the machine to the computer via an Ethernet cable or wireless LAN. Then, configure the
network settings in accordance with the network environment. Finally, install the printer driver.
This guide uses Windows 7/10 procedures for its examples. Procedures and screens might vary
depending on the operating system you are using.
• A wired connection and wireless LAN connection cannot be used simultaneously.
Connecting the Machine via Ethernet Interface
Be sure to install all necessary network equipment, such as hubs, etc. before connecting the Ethernet
cable to the machine.
You can connect a 10BASE-T or 100BASE-TX cable to the machine.
• Ethernet cables are not supplied with this machine. Select your cable according to the network
environment.
1. Open the port cover.
2. Preparing for Printing
50
To Next Page
Loading...
