Ricoh Ri 100 - Installing the Printer Driver

Configure other settings if needed.
8. Click [OK].
9. Click [Administrator Logout].
10. Turn the machine off.
11. Remove the Ethernet cable, and then connect the wireless LAN cable.
12. Turn the machine on.
Setting is complete.
Configuring Settings Using the Control Panel
• For details, see notes for Wireless LAN users on the access point manufacturer's Web site or
page 144 "Using the [Host Interface] Menu".
1. Press the [ /Menu] key.
2. Press the [ ] or [ /Menu] key to display the [Host Interface] menu, and then press the
[#Enter] key.
3. Press the [ ] or [ /Menu] key to display [Wireless LAN], and then press the [#Enter] key.
4. Press the [ ] or [ /Menu] key to display [Security Method], and then press the [#Enter]
key.
5. Configure the wireless LAN settings.
Installing the Printer Driver
Once the machine is connected to the computer, install the printer driver.
There are two installation methods. Install the printer driver using one of these methods.
• Quick Install for Network
Install the printer driver automatically. See page 62 "Quick Install for network".
• Manual install
Configure the settings of the printer driver manually and install it. See page 64 "Installing the
Printer Driver Manually Using the Network".
Quick Install for network
Follow the procedure below to install the printer driver.
• Only administrators can perform this installation. Log on as a member of the Administrators group.
2. Preparing for Printing
62