Ricoh Ri 100 - Page 63

If the WPA authentication method is WPA-PSK or WPA2-PSK
1
2
DSB205
1. Select [WPA-PSK] or [WPA2-PSK].
2. Enter the PSK (Pre-Shared Key), and then select the Apply check box.
3. Configure other settings if needed.
If the WPA authentication method is WPA or WPA2
1
2
3
4
DSB204
1. Select [WPA] or [WPA2].
2. Enter the user name for Extensible Authentication Protocol (EAP).
3. Select the EAP authentication type.
4. Enter the password for Protected Extensible Authentication Protocol (PEAP), and then
select the [Apply] check box.
You can configure this setting if [EAP Type] is set to [PEAP].
Connecting the Computer and Installing the Software (Network Connection)
61