Fixing Ink
Use the optional finisher to fix the ink to the fabric.
When using the multi tray, remove the fabric from the cassette, and then fix the ink to the fabric.
• Do not use the optional finisher while using the multi tray and the sleeve attachment because using
it may cause a failure. Remove the fabric from the multi tray and the sleeve attachment, and then fix
the ink to the fabric.
• Do not heat the multi tray table or the fabric placed on the multi tray table with the optional finisher.
Doing so may deform or damage the table.
• As the A4 standard tray and A5 tray becomes hot when continuously used on the optional finisher,
give an interval of five minutes or longer to set them after they are pulled out.
• For reference, in the case of a commercially available heat press, ink was fixed at 330°F (approx.
165°C) in 90 seconds.
• When using the finisher, you can carry out heat press processing for the T-shirt loaded in the A4
standard tray or A5 tray.
Fixing Ink
97
To Next Page
Loading...
