Tuck the fabric so that no folds or wrinkles remain at the edges of the table.
Loading a Sleeve in the Multi Tray
When printing on the sleeves of a T-shirt, attach the sleeve attachment to the multi tray and load the
sleeves in the sleeve attachment.
• If you carry out printing with the edges of the fabric still outside the table, the fabric or machine
might be damaged. After fixing the fabric, make sure that it fits within the width of the cassette.
• When fixing sleeves with tape, stick the tape to the side of the sleeve attachment. If you wrap the
tape onto the bottom of the multi tray, you may not be able to set the sleeve attachment correctly
on the cassette stand.
• Tuck the protruding fabric under the front side and the side of the sleeve attachment. If you only
tuck the protruding fabric under the front side, a height detection error may occur or the table may
be damaged because of the thickness of the fabric.
1. Press the [Power] key.
Remove the cassette after turning the power on. If the cassette is mistakenly removed before turning
the power on, turn the power off once, and then turn the power on again.
2. Check that the cassette stand comes to the front.
If the cassette stand does not come to the front, press the [Tray] key and move the cassette to the
front.
3. Lift the cassette slightly, pull it to the front to remove it.
Loading Fabrics
77
To Next Page
Loading...
