9. After closing the cover, if there are still wrinkles or slack on the printing surface at the
center of the table, push both ends of the cassette lightly and push the fabric under the
table.
After closing the cover, check that the fabric is not caught between the cover and the cassette.
Loading a Fabric in the Multi Tray
When you want to print on fabrics that cannot be loaded on the A4 standard tray or A5 tray, use the
multi tray at your own risk.
• If you carry out printing with the edges of the fabric still outside the table, the fabric or machine
might be damaged. After fixing the fabric, make sure that it fits within the width of the cassette.
• When setting the fabric in the multi tray, set it in the center of the table. Otherwise, the table may tilt
and the height of the table may not be correctly detected, which could deteriorate print quality.
• When setting multiple pieces of fabric on the multi tray, set the thickest fabric in the center of the
table. Otherwise, the height of the table may not be correctly detected, and the garment may
misfeed and cause an error.
Loading Fabrics
75
To Next Page
Loading...
