Move the machine to a more suitable environment.
1. Press and hold down the [Power] key for one second.
2. Place the machine in an environment where a temperature range is between 10 and
40°C (50 and 104°F).
3. Turn the machine on.
• Even after the power is turned on, the machine may remain in standby mode until it acclimates to
the room temperature. If this happens, wait until the power lamp stops flashing and stays lit.
• For details about what conditions the machine can be used under (ambient temperature and
humidity range), see page 28 "Checking the Computer and Installation Area".
Printer Error
An error has occurred in the machine.
Turn the machine off, and then turn it on again.
• If the error still does not clear after the power is turned back on, contact your sales or service
representative.
Network Interface Error
An error in the Ethernet port network function has occurred.
Turn the machine off, and then turn it on again.
• If the message reappears, contact your sales or service representative.
Maintenance Failed
Head cleaning, head flushing, or other maintenance operations have failed.
Run the maintenance again after clearing the error.
You can clear a maintenance error as follows:
• The machine receives another print job.
• Press the [#Enter] key.
9. Troubleshooting
236
To Next Page
Loading...
