Ricoh Ri 100 - Connecting the Computer and Installing the Software (USB Connection); Connecting the Machine Via USB

Connecting the Computer and Installing the
Software (USB Connection)
Connect the machine to the computer via a USB cable. Then, install the printer driver. Finally, configure
the network share settings as necessary.
This guide uses Windows 7/10 procedures for its examples. Procedures and screens might vary
depending on the operating system you are using.
Connecting the Machine via USB
1. Make sure the machine is off.
DSB153
2. Turn on the power of the computer.
Quit all applications currently running.
If the "Add New Hardware Wizard" appears, click [Cancel], and then turn the machine off.
3. Open the port cover.
DSA184
4. Insert the USB cable's hexagonal (type B) plug into the port.
Check the shape and direction of the plug and make sure the cable is fully inserted.
Connecting the Computer and Installing the Software (USB Connection)
43