Ricoh Ri 100 - Changing the [Host Interface] Menu; Precautions to Take When Using in a Network

• Auto
Default: [Auto]
Port Setting
• On
• Off
Default: [Off]
Changing the [Host Interface] Menu
This section gives an example of changing a setting in the [Host Interface] menu.
1. Press the [ /Menu] key.
2. Press the [ ] or [ /Menu] key to display [Host Interface], and then press the [#Enter]
key.
<Menu>
Host Interface
3. Press the [ ] or [ /Menu] key to display [I/O Timeout], and then press the [#Enter] key.
<Host Interface>
I/O Timeout
4. Press the [ ] or [ /Menu] key to display [20 seconds], and then press the [#Enter] key.
<I/O Timeout>
20 seconds
5. Press the [Escape] key.
Precautions to Take When Using in a Network
Using DHCP
• You can register the host name to a DNS server. In the Web Image Monitor menu, you can
enable or disable [Notify Host Name to DHCP Server]. For details, see page 155 "Changing
the Machine Settings".
• The DHCP Relay Agent is not supported.
• Supported DHCP server operating systems are: Windows Server 2008, and UNIX standard.
• The IP address acquired from DHCP can be checked on the configuration page. For details
about printing a configuration page, see page 117 "Using the [List/Test Print] Menu".
5. Machine Setup Menus
148