Notes on the Installation
Although the Windows security warning may appear during installation, ignore it and continue with
the installation.
1. Insert the CD-ROM in the CD-ROM drive.
Quit all other applications currently running.
2. Select a language for the interface, and then click [OK].
3. Click [Quick Install for Network].
4. Read the entire license agreement carefully. If you accept its terms, click [I accept the
agreement.], and then click [Next >].
5. Check that the power of the machine turns on, the Ethernet cable is connected, and the IP
Address is set, and then click [Next].
The search for the network printer starts.
6. Click [Next >].
7. Click [Continue].
Installation starts.
8. If you want to make initial settings for the printer, click [Set Now].
9. Make initial settings, and then click [OK].
10. Select whether or not to open the Status Monitor automatically, and then click [Next >].
11. Click [Finish].
When the dialog box asking whether you want to restart now appears, select [Yes, restart now.],
and then click [Finish].
The printer driver is now installed.
• The installer launch automatically as Auto Run programs when you insert the CD-ROM. Auto Run
might not work automatically with certain OS settings. If this is the case, double-click "SETUP.EXE",
located on the CD-ROM root directory, or click [Run SETUP.EXE] in the [AutoPlay] dialog box.
• If a message prompting you to restart the computer appears, restart the computer.
• Confirm the printer driver is correctly installed by checking the Power lamp is lit, and then
performing a test print. To perform a test print, open the [Printer Properties] dialog box, click [Print
Test Page] on the [General] tab. If the test page does not print properly, see page 144 "Using the
[Host Interface] Menu".
Connecting the Computer and Installing the Software (Network Connection)
63
To Next Page
Loading...
