Message Causes Solutions
Adjust height, press Start
to / restart or Tray to reset
garment
Thin fabric (up to 16 mm
(about 0.6 inches) thick)
is loaded on the bottom
row of the multi tray.
Load thin fabric (up to 16 mm (about 0.6
inches) thick) on the top row of the multi tray.
Adjust height, press Start
to / restart or Tray to reset
garment
Thick fabric (16 to 32
mm (about 0.6 to 1.3
inches) thick) is loaded
on the top row of the
multi tray.
Load thick fabric (16 to 32 mm (about 0.6 to
1.3 inches) thick) on the bottom row of the
multi tray.
Adjust height, press Start
to / restart or Tray to reset
garment
Fabric that is 4 mm
(about 0.2 inches) or
thicker is loaded on the
top row of the sleeve
attachment.
Load fabric that is 4 mm (about 0.2 inches)
or thicker on the bottom row of the sleeve
attachment.
Adjust height, press Start
to / restart or Tray to reset
garment
Fabric that is 20 mm
(about 0.8 inches) or
thicker is loaded on the
bottom row of the sleeve
attachment.
Load fabric that is up to 20 mm (about 0.8
inches) thick on the top row of the sleeve
attachment.
Adjust height, press Start
to / restart or Tray to reset
garment
Fabric that is 4 mm
(about 0.2 inches) or
thicker is loaded on the
A4 standard tray or A5
tray.
Load fabric that is up to 4 mm (about 0.2
inches) thick on the A4 standard tray or A5
tray.
Adjust height, press Start
to / restart or Tray to reset
garment
Fabric that is 32 mm
(about 1.3 inches) or
thicker is loaded on the
multi tray or the sleeve
attachment.
Load fabric that is up to 32 mm (about 1.3
inches) thick on the multi tray or the sleeve
attachment.
Adjust height, press Start
to / restart or Tray to reset
garment
Fabric is not set in the
center of the multi tray
table.
When setting the fabric in the multi tray, set it
in the center of the table.
Error & Status Messages on the Display
225
To Next Page
Loading...
