Ricoh Ri 100 - Page 56

1. Before configuring the wireless LAN settings, configure the machine's IP address or make
DHCP enabled.
For details about configuring the machine's IP address, see page 52 "Network Settings for Ethernet
and Wireless LAN".
2. Check that the access point is operating.
CHV600
3. Plug the wireless LAN cable into the Ethernet port before configuring the wireless LAN
settings.
DSA343
Selecting the configuration method
The configuration method depends on the access point being used.
"Easy Setup" is a function for automatically configuring the wireless LAN settings. The actual name of the
function may vary depending on the access point being used. See the access point manual.
• To use "Easy Setup", the access point must be set up with no security method, or be set up with one
of the following security method.
• WPS-PSK(AES)
• WPA2-PSK(AES)
2. Preparing for Printing
54