1.Detailed Descriptions
41
Saddle Stitching with This Finisher
Until now, very heavy pressure had to be applied in order to shape the saddle, and this could not be
done unless the finisher was very large. This finisher, however, in spite of being very small, uses the
device described below to achieve a better saddle shape.
1. Pressure is applied to the fold with a roller to form the saddle.
2. Pressure is applied while the paper is buckled at the top and bottom with two rollers to form the
saddle. The rollers move to front and back to strengthen the crease with two folds, not just one fold.
Components
To Next Page
Loading...
