4 Installation
This section is intended for the dealer of the FertiMiX-Go!.
This section describes the following subjects:
Installation requirements
Connecting the various components
In section "Step-by-step installation and commissioning instructions" on
page30 you will find an overview of the steps. Use the Appendix: "Checklist
for step-by-step installation procedure" on page62 to check that all steps
have been completed.
4.1 Installation requirements
This section describes the requirements for installing the FertiMiX.
4.1.1 Dealer/installer requirements
The installation of the FertiMiX-Go! and the other components, together with the
installation and configuration of the software, must be carried out by a qualified
dealer. Ridder Growing Solutions considers a dealer/installer to be qualified if that
person meets the following requirements:
The dealer:
has a broad knowledge of installation technology (hydronic and electronic).
can understand and carry out instructions in English.
is familiar with the contents of this installation and user manual.
4.1.2 Installation requirements
The following requirements apply to installing the FertiMiX-Go! on site:
Make sure that the FertiMiX-Go! is level
Install the FertiMiX-Go! on a hard surface that is able to support its weight
Install the unit in a dry, dust-free location (1)
1
.
Check the ambient temperature. This should be between 5°C - 30°C (41°F -
86°F) (2).
Check the relative humidity (RV). This may not exceed 85%, without
condensation (3).
Make sure that the unit is not exposed to dripping or splashing water.
Avoid exposure to direct sunlight (5).
Avoid exposure to hazardous substances (6).
Avoid exposure to unnecessary vibrations (7).
1
The numbers refer to the numbers in Figure 4-1.
FertiMiX
28
To Next Page
Loading...