Risco Agility Installer Manual

AgilityInstallerManual
Page 4-15
System: Settings
Parameter Default Range
EraseWirelessDevice
 
Erasewirelessdeviceswithoutchangingthesystemcurrentprogrammedparameters.
Language
Setsthesystemlanguage(Email,SMSandkeypadlanguage)
Standards
EN50131
NO 
SetsthepanelprogrammingoptionsincompliancewithENstandards.(See
AppendixD)
DD243
NO 
SetsthepanelprogrammingoptionsincompliancewithDD243standards.
1.6 Service Information
TheServiceInformationmenuenablesyoutoinsertinformationaccessibletothesystemʹs
usersofthealarmcompanyfromwhomtheserviceisobtained.
System: Service Information
Parameter Default Range
Name
 Any16characters
Enablesyoutoinsertand/oreditthenameofthealarmcompanyfromwhomservice
maybeobtained.Theinformationcanbeviewedbytheuserusingthewirelesskeypad.
Phone
 Any16characters
Enablesyoutoinsertand/oredittheservicephonenumber.Theinformationcanbe
viewedbytheuserusingthewirelesskeypad
2. Programming: Radio Devices Menu
TheRadioDevicesmenuprovidesaccesstosub‐menusthatareusedforprogramming,
definingandeditingeachofthesystemʹswirelessdevices.TheRadioDevicesmenuis
dividedintothefollowingsub‐menus:
1.Allocation
2.Modification
3.Identification
2.1 Allocation
Eachwirelessdevicemustbeidentifiedtothesystemreceiverbeforeitsparameterscanbe
configured.SeeChapter3forfurtherinformationontheallocationprocedures.

Risco Agility Specifications

General

Remote Management	Yes
Mobile App	Yes
Voice Module	Optional
Backup Battery	Yes
Two-Way Voice	Yes
Event Reporting	Yes
Remote Control	Yes
Siren Output	Yes
Type	Wireless
Communication	GSM
Compatibility	Risco accessories
Power Supply	Mains powered with battery backup